Zmorph 2

Zmorph 2.0S - Z-endstop [tuning]

This endstop has two important changes compared to the original one: it can be easy removed and there are no nuts so screw is running easy (important when you have to often change it's position). Print with ABS. Then mount it like original (with special block inside: "z_endstop_b"). WARNING! You have to make thread (for endstop screw) but don't do this by special tools! Just gently drive inside normal M4 screw. Thread should be tight because it's only thing which is holding endstop screw on place. It should drive easy but with noticeable resistance.

Designed by kpawel on August 09, 2016

Design's files:

No one has added any comments for this design so far.